Bill Schifsky Funny Car

dckrsn Wed Mar 21, 2012 9:06 pm

Stumbled across this tonight and thought some of you guys might enjoy seeing it.
Bob
Bill Schifsky Funny Car Cox12

**Admin** Wed Mar 21, 2012 9:07 pm

https://sites.google.com/site/coxenginecollection/cox-engine-blog/1971coxpintofunnycarnotthemodel

**RknRusty** Wed Mar 21, 2012 9:30 pm

Admin wrote:https://sites.google.com/site/coxenginecollection/cox-engine-blog/1971coxpintofunnycarnotthemodel

Did you see the Model car sitting on top of the intake stacks. I couldn't quite read the valve covers. It might say MOPAR, but I'm not sure. Maybe Moroso.

**Admin** Wed Mar 21, 2012 9:40 pm

RknRusty wrote:
Admin wrote:https://sites.google.com/site/coxenginecollection/cox-engine-blog/1971coxpintofunnycarnotthemodel
Did you see the Model car sitting on top of the intake stacks. I couldn't quite read the valve covers. It might say MOPAR, but I'm not sure. Maybe Moroso.

I think they were Milodon, it is a bit hard to see. I do remember looking the car over and looking at every detail. I remember scanning the tables really close for Cox engines and items then I looked up and said "DAMN!". I found that $40 Cox Jeep there (not from the guy who had the actual car).

PV Pilot Wed Mar 21, 2012 11:06 pm

Nothing like pitting in the dirt at the dragstrip. done that, and done that!. Probably will again this summer. Spokane motorsports park is dirtball pit parking.

**RknRusty** Thu Mar 22, 2012 1:49 am

Yeah I changed a throwout bearing lying in sand and pinestraw at the dragstrip one time. It's been a long time since the days when I could lay a Muncie 4 speed on my chest and wiggle under the car, pick it up and jam it in the hole.

**Cribbs74** Thu Mar 22, 2012 8:10 am

RknRusty wrote:Yeah I changed a throwout bearing lying in sand and pinestraw at the dragstrip one time. It's been a long time since the days when I could lay a Muncie 4 speed on my chest and wiggle under the car, pick it up and jam it in the hole.

Lol, I had a 5.0 Mustang that had a bad tranny that I was dropping weekly trying to find the source of the problem. I didn't have enough money to do a rebuild. Same deal, benchpressed it in and out each time. Now I can drop and stab a T-5 in 45 Mins. There's a useless skill!

PV Pilot Thu Mar 22, 2012 8:32 am

Had to bench press a turbo 400 in to place in the gravel,,sucked!

Tunnelling my way to the oil pan to do a oil swap. Reminded me of "The Great Escape" movie. On my back, wiggeling the boulders out of the way.