Re: Is This an average Medallion

TopBannana Wed Aug 05, 2015 9:22 am

So I bolted it up and ran it a couple of days ago
And using Cox25% supersuper fuel it ran smooth
I ran it rich and show first time
No two boats on the left side came right out
seeing how I was using it on wood and using wooden screws
luckily I put a tiny bit of fuel in it just for the first time
in case of anything happened and luckily the other 2 screws did not come out
But until I get a proper Stand I won't run it

TopBannana Sat Aug 15, 2015 1:37 pm

Well Finally have a video!
I reinforced my stand and is solid
I put a #1 Thin wall cyl. on and stock needle off my .09 for the time being
Heres the vid.....

-Trevor

getback Sat Aug 15, 2015 3:46 pm

Sounds good / strong little engine , glad you got that stand so you can run some engines and not get hurt , Be careful and have fun !! Clapping

Eric

happydad Sat Aug 15, 2015 5:18 pm

Bootlegger wrote:As a neewbe I don't know what a product engine needle is. I have an .049 medallion that I picked up at a swap meet, it runs well, and I have another one on the way to me.
I would like to find a couple of the correct venturi's , spray bar/with needles.
Any one know where I might get these?
Thanks a lot...

I happen to have several of the red plastic venturi for the Medallion. They do not have the spray bar or needle valve. I understand the spray bar and needle valve are hard to find. They were available on ebay thru "california dan" at one time.

please PM if you would like a picture of the red plastic medallion venturi only.

happydad

crankbndr Sun Aug 16, 2015 2:03 pm

Ex has Medallion spray bars on eBay now

http://www.ebay.com/itm/Cox-049-09-Medallion-Airplane-Engine-Spraybar-049-09-/281774965635?hash=item419b18c383

TopBannana Sun Aug 16, 2015 7:31 pm

crankbndr wrote:Ex has Medallion spray bars on eBay now

http://www.ebay.com/itm/Cox-049-09-Medallion-Airplane-Engine-Spraybar-049-09-/281774965635?hash=item419b18c383

Now all we need is medallion needle valve

Sponsored content